RoboGuard TRX005, Руководство техника

Страница: 4 / 44

Roboguard 4
Walk Test Mode
Setting up the beam array for optimal performance
After mounting your Roboguard make sure it is detecting intruders. If
its range seems very short you will need to adjust the beams to make
them level with the ground and parallel to each other.
‘Walk Test’ allows you to hear the beams as they detect, and make
these adjustments.
Remember both top and bottom beams need to be broken for
the roboguard to detect intruder.
1.
Remove the battery cover from the
Roboguard, or press and release the
tamper switch - the on-board buzzer will
activate for about 20 minutes before
going silent again.
2. Ensure that the securing screw of both
top and bottom sensor boxes is over the middle line of the
adjustment slot (see picture).
3. The Roboguard will now buzz once for every time the bottom sensor
detects, and twice for every time the top sensor detects.
You
should hear three ‘buzzes’ – which means that both sensors
are detecting.
4. Walk across the path of the beams, from left to right and
back again , and keep increasing the distance between you and the
Roboguard. If you walk straight towards a guard it is not very
efficient and will only detect at close range.
5. If only 1 ‘buzz’ is heard, only the bottom sensor is detecting you
and the top beams are most probably adjusted too high.
6. Top Sensor: Loosen the retaining screw. Sliding the box up will
lower the beam, pulling it down will raise the beam (seesaw effect),
1mm adjust will move the beam 1 metre up or down over 10
metres, so make slight adjustments until you hear the beam strike
you. Tighten the retaining screw.
7. Follow the same instructions if only the top sensor is detecting you,
this time moving the bottom sensor box.
8.
Work slowly and methodically and check every beam in the pattern.
Pause for 2 seconds between ‘buzzes’ to catch the next beam.
9.
Note: move slowly – if only 1 sensor is detecting you the
Roboguard takes longer to react (it is waiting for the other
sensor to detect).