RoboGuard TRX005, Руководство техника

Страница: 27 / 44

Roboguard 27
Ensure that the 0V connections are common between
the alarm panel and the keypad.
NOTE: DO NOT WIRE ANY POWER ONTO THE OUTPUT
PORT PINS.
General Operation
The keypad is used to supervise and control Roboguards and to report
activity audibly (with speaker connected), visually and electronically.
The keypad monitors and supervises up to four Roboguards. If an
intruder is detected the speaker will beep the number of the zone i.e.
zone one, one beep, zone three, three beeps etc; the corresponding
LED will flash and the selected output switch will activate.
More than 1 keypad can be connected to a single receiver.
Roboguard advises not more than 4 Keypads to 1 receiver.
GREEN Zone LEDs (zone control and intruder detection)
Each of the keypad zones can be individually switched on or off.
Switching the zone off does NOT disable the supervision or the tamper
monitoring. If the green led for the zone is OFF then the zone is
disabled. If it is ON then the zone is ON and not triggered. If it is
FLASHING then the zone is ON and has been triggered. Pushing the
zone button will change the state of the led from OFF to ON and back
again or from FLASHING to OFF to ON.
NOTE: Zones which do not have Roboguards programmed in will not
function.
RED Tamper LED FLASHING (Tamper Detection Triggered)
If a Roboguard’s is battery cover is removed, a tamper signal will
automatically be sent to the keypad. It will sound the speaker 10
times, permanently flash the red tamper LED and activate one of the
output switches. To establish which Roboguard was tampered with and
to reset the tamper detect LED you must do the following:
1.
Press and release the tamper button (tamper LED on, keypad is now
in tamper detected display mode)
2. The zone LED for the Roboguard that has been tampered with will be
solid (on).