Robinson Polytunnels 10ft Wide Polytunnel, Руководство по сборке и инструкция

Страница: 11 / 28

10ft Wide Polytunnel Assembly Instructions
Copyright © Robinson Polytunnels 2009 - 2018
11
7. TIMBER SIDE RAIL (OPTION)
1 Set the M25 fittings and H25 fittings 90cm above the
M20/SC20 fittings on the Foundation Tubes.
2 Start at one end of the polytunnel, at the door post. Place
the end of the timber 75mm x 38mm x 240cm long up to
the side of the door post. Mark the timber to the outside
face of the M25 fitting and cut to length.
3 Re-position the piece of timber and mark through the
hole on the M25 fitting and drill the timber to accept an
8mm diameter bolt.
Tip! Use the timber offcuts wherever they are long
enough.
4 Bolt the timber to the M25 fitting with an M8 x 50
coach bolt and nut.
5 Using a flat nail plate, fix the timber to the door
post with 30mm long twist nails. Make sure the
timber is parallel to the base rail. Nail through the
door post into the end of the timber with a
125mm long nail.
6 Hold the next timber along the side of the polytunnel, flush
with the outside of the timber side rail on the end of the
polytunnel. Mark through the hole in the M25 fitting and drill
to accept an M8 bolt.
7 Bolt the timber to the M25 fitting with an M8 x 50 coach bolt
and nut.
8 On the next hoop, mark the timber through the two holes in the H25
fitting. Drill to accept an M8 bolt and fix in place with two M8 x 50
coach bolts and nuts.
9 Continue until you reach the end of the polytunnel and trim the last
timber to length.