Robinson Polytunnels 10ft Wide Polytunnel, Руководство по сборке и инструкция

Страница: 17 / 28

10ft Wide Polytunnel Assembly Instructions
Copyright © Robinson Polytunnels 2009 - 2018
17
11. FITTING THE POLYTHENE – TRENCHING METHOD
1 Dig a trench around the perimeter of the
polytunnel, approximately 15cm away from the
Foundation Tubes. The trench should be
approximately 30cm wide x 30cm deep.
Tip! Wait for a calm and preferably warm day to
sheet your polytunnel. It will be much easier
and you’ll probably do a better job!
2 Unroll and unfold the polythene and drape it over the
polytunnel framework with an equal amount over each side
and each end.
3 Carefully slice the polythene diagonally from the top corners
of the doorway. Trim the bottom off the central flap so that it
hangs approximately 30cm below the door lintel.
1 Use a full batten to fit in the rebate above the doorway.
2 Place the batten underneath the flap of polythene and
roll the batten into the polythene, up to the rebate. Nail
the batten in place. Note, it is preferable to have a
couple of small pleats in the flap of polythene.
3 Repeat at the other end, PULLING THE POLYTHENE AS
TIGHT AS POSSIBLE.