Robinson Polytunnels 10ft Wide Polytunnel, Руководство по сборке и инструкция

Страница: 24 / 28

10ft Wide Polytunnel Assembly Instructions
Copyright © Robinson Polytunnels 2009 - 2018
24
8 Starting with the mid-rail, nail a batten over the
polythene and net. Use 50mm long nails, 9 nails per
batten. Next nail on the end battens and finally the side
battens.
9 Trim off the surplus polythene and net.
10 Screw the hinges onto the front face of the door,
ensuring that the door is hinged on the side which
you want.
11 Position the door with the end frame, resting
on packing pieces to set the gap around the
door. Screw the hinges to the door post.
12 Screw the auto gate latch and latching bar to
the door post and door vertical, respectively.
13 Drill a hole through the door post for the pull-
string. The polyester cord (pull-string) is tied
around the sneck of the gate latch, threaded
through the hole and a loop tied on the end.
This operates the latch from the inside of the
Polytunnel.
If you are unsure about any part of the assembly procedure you can contact our office
between 8:30am and 5:00pm, Monday to Friday on 01282 501252