EAGLE 2 Operator’s Manual
Optional Accessories • 25
•
4 foot stainless steel probe
Figure 11: 4 Foot Stainless Steel Probe
This probe is designed for areas where it is necessary to put the probe tip in areas that
are out of reach for even the 30 inch probes. A stainless steel probe tube is used
because the length of the probe tube requires a high degree of rigidity. Stainless steel is
more rigid than other normally used materials. A small breather hole near the end of
the probe tube prevents interruption of sampling and a low flow alarm if the probe tip
is blocked.
•
Barhole probe
Figure 12: Barhole Probe
This probe is designed specifically for barhole testing. See “Appendix K: Using the
EAGLE 2 in Bar Hole Mode” for an in-depth discussion of using the EAGLE 2 in Bar
Hole Mode.
•
10 inch probe with dust filter
Figure 13: 10 Inch Probe With Dust Filter
This probe is designed for use where drawing water or moisture into the EAGLE 2 is
not a concern. Instead of a hydrophobic filter, a cotton dust filter is used.
•
32 inch telescoping probe with dust filter
Figure 14: 32 Inch Telescoping Probe with Dust Filter
This probe is designed for use where it is necessary to put the probe tip in areas not
accessible with the 10 inch probe with dust filter and applications where the probe tube
must be collapsible for storage.
www.
.com
1.800.561.8187
