USB-CPU configuration
By actuating this button, the "Network Interface NW" card (Fig. 5 ), which is currently
connected to the PC, is reprogrammed in order to remedy an increase in the
number of virtual COM ports. In addition, the setup program is automatically sup-
plied with appropriate parameters so that the actual programming procedure does
not require any further operations. The configuration program is automatically
installed during the program installation.
INFORMATION
This configuration only has to be performed for component assemblies with a pro-
duction date prior to July 8, 2014 ( "Network Interface NW" card with component
assembly numbers prior to 0214 and from 0214-0001 up to and including
0214-0349).
If the system is no longer to be recognized following USB configuration, then config-
uration has to be performed again. Configuration is then only possible if the mainte-
nance program displays "No device connected".
Time
● Read out time: Reads the time out of the CPU of the system and displays it in
the
„time”
and
„date”
fields.
● Set date/time: Writes the values from the
„time and date field”
into the CPU of
the system.
● System time: Sets the
„time”
and
„date”
fields to the PC system time.
● Time/date field: Defines the time that is to be written into the system by means of
„Set date/time”
. Manipulations of these fields do not become effective until the
„Set date/time”
button is clicked.
Maintenance program
Operating Instructions / DET-AC III Slave / 916007 / 05-2016 / en_US
61
Содержание 7338.321
Страница 82: ...Appendix Appendix Operating Instructions DET AC III Slave 916007 05 2016 en_US 82 ...
Страница 84: ...Operating Instructions DET AC III Slave 916007 05 2016 en_US 84 ...
Страница 85: ......
Страница 86: ...Ì916007 Î ...
