Operating Manual Version 6.3-04 of 10.10.18
23
(Optional) In the
‘F1’
mode when the electrode is placed on the skin, a
short high-pitch beep sounds. In 1-3 sec – a short low-pitch beep. All four
LEDs indicate a level of initial reaction during 1 second after the second beep:
Reaction level
Indication
Reaction
< 18
All LEDs are switched off
18 <=
Reaction
< 25
LED
‘F1’
lights up
25 <=
Reaction
< 40
LEDs
‘F1’
and
‘F2’
light up
40 <=
Reaction
< 60
LEDs
‘F1’, ‘F2’
and
5
light up
60 <=
Reaction
LEDs
‘F1’, ‘F2’
,
5
and
4
light up
ATTENTION!
In fact there is a double indication: a relative val-
ue of current reaction to initial one – by
LEDs
and sounds, and an
absolute maximum of reaction – by
clicks
.
4.3.7
Enabling/disabling sounds:
to enable sounds, press the
‘ ’
and
‘
’
buttons simultaneously
(the SCENAR device emits a beep);
to disable sounds, press the
‘
’
and
‘ ’
buttons simultaneously
(no sounds).
4.3.8
(Optional) To
lock/unlock a keyboard press and hold the
‘ ’
and
‘
’
buttons (for about 2 sec) until the SCENAR device emits a two-
tone descending/ascending beep.
If the SCENAR device switches off automatically, the keyboard will
be unlocked when the SCENAR device is switched on next time.
4.3.9
To switch the SCENAR device on with the energy level set be-
fore it was switched off press and hold the
‘ ’
and
‘
’
buttons (for about
2 sec) until the SCENAR device emits an intermittent high-pitch beep.
ATTENTION!
When the SCENAR device is switched on with the
energy level set before it was switched off, the sound indication is
different from default.
5 GETTING STARTED
ATTENTION!
Remove the protective film from the built-in elec-
trode before using the SCENAR device.
5.1 SCENAR HOME
5.1.1
Remove the battery cover and insert the battery observing polarity.
If the battery is installed correctly a beep sounds and the
‘
’
LED
lights up. Otherwise reset the SCENAR device (refer to item 5.1.2).
