Operating Manual Version 6.3-04 of 10.10.18
15
ATTENTION!
In fact there is a double indication: a relative val-
ue of current reaction to initial one – by
LEDs
and sounds, and an
absolute maximum of reaction – by
clicks
.
4.1.7
To set the AM mode, press the
‘ ’
button (sequence of single
taps) until the
‘Am’
LED starts blinking. While the
‘Am’
LED is blinking,
press the
‘ ’
button to switch the mode on, and press the
‘ ’
button to
switch the mode off. The mode switching on is accompanied by an ascend-
ing two-tone beep, the switching off – by a descending two-tone beep.
In the Amplitude modulation mode the stimulation is intermittent:
3 sec – stimulation, 1 sec – pause. The
‘
’
LED brightness is changing.
4.1.8
To set the FM mode press the
‘ ’
button (sequence of single
taps) until the
‘Fm’
LED starts blinking. While the
‘Fm’
LED is blinking,
press the
‘
’
button to switch the mode on, and press the
‘
’
button to
switch the mode off. The mode switching on is accompanied by an ascend-
ing two-tone beep, the mode switching off – by a descending two-tone beep.
In the Frequency modulation mode the stimulation frequency is con-
tinuously changing from 30 to 120 Hz and back. The
‘
’
LED brightness
is changing depending on the pulse frequency.
4.1.9
Some modes may be used together: ‘
D+Am’
,
‘D+Fm’,
‘D+Am+Fm’,
‘Am+Fm’
. For this purpose, switch on the required modes
sequentially.
(Optional) For user’s convenience SCENAR has two pre-installed
modes (
Presets
).
To enter the
preselection mode
press the
‘ ’
button (sequence of
single taps) until the ‘rolling light’ (sequential short flashes of the LEDs
during 2 seconds). In this mode you can select one of two presets by press-
ing the
‘ ’
button
.
Selected and set mode is indicated by LEDs and sound:
Preset
1
(single beep,
‘Am’
and
‘Fm’
LEDs go ON): frequency
modulation and amplitude modulation are switched ON.
Preset 2
(double beep,
‘D’
and
‘4’
LEDs go ON): the number of
pulses in a batch and the gap between the pulses are controlled
automatically at the 90 Hz frequency.
While any
Preset
is ON, the switching to another mode by pressing
the
‘ ’
button will be locked and LEDs will be glowing according to the
active
Preset
. Turn the
Preset
OFF to return to regular operation mode.
To turn the
Preset
OFF press the
‘ ’
button, while the LEDs are
glowing according to the active
Preset
. When the Preset is turned OFF, the
energy level will be saved, all other parameters will be set to default
(
‘Fm’
,
‘Am’
and
‘D’
are turned OFF, the frequency is 90 Hz).
