Operating Manual Version 6.3-04 of 10.10.18
22
4, 5, ‘F1’, ‘F2’
– from 76 to 100 %;
to display current reaction to the initial reaction ratio in the
‘F2’
(screening) mode.
4.3.3
On the front side of the casing there are following buttons:
8
–
‘ ’
button
– switches the SCENAR device
ON
and
OFF
;
9
–
‘ ’
button
– switches between the stimulation modes;
10
–
‘ ’
button
– increases the energy level;
11
–
‘ ’
button
– decreases the energy level.
4.3.4
On the left side of the casing there is a jack (13) intended for con-
necting the add-on electrodes which can be supplied additionally upon request.
ATTENTION!
Only the add-on electrodes produced by the
SCENAR manufacturer can be used. Be careful: use only plug-
compatible add-on electrodes. Using the incompatible or pro-
duced by the other manufacturer add-on electrodes may result in
damaging the jack and making the warranty invalid!
4.3.5
To increase or decrease the energy level either press the
‘ ’
or
‘ ’
button respectively step by step (1 step = 1 unit) or press and hold the
button (speedy adjustment).
The energy level increase is accompanied by clicks at the adjustment rate,
the increase of the
‘
’
LED brightness and the
5
,
‘F1’
and
‘F2’
LEDs
light-
ing up one after another. A long beep indicates the upper energy level limit.
The energy level decrease is accompanied by clicks at the adjustment
rate, the decrease of the
‘
’
LED brightness and the
‘F2’
,
‘F1’
and
5
LEDs
going out one after another. A long beep indicates the lower energy level limit.
4.3.6
Press the
‘
’
button to select
the
‘F1’
mode
(stimulation in Dos-
ing mode with the constant frequency of 60 Hz and ‘
Am
’) and the
‘F2’
mode (stimulation with the constant frequency of 90 Hz while the number
of pulses in a batch and the gap between the pulses are controlled automat-
ically). This is accompanied by the
‘F1’
or
‘F2’
LED (respectively) flashing
on for 2 seconds.
In the
‘F1’
mode
,
when the electrode is placed on the skin, a short
high-pitch beep sounds. In 1-3 sec – a short low-pitch beep sounds and the
‘F2’
LED flashes on shortly
.
While delivering the dose, the
‘F2’
,
‘F1’
,
5
,
4
LEDs light up sequentially (by one or several together), single beeps may
sound – depending on the dose delivery rate.
When the dose is reached, all the LEDs flash on shortly and a two-
tone beep sounds.
The LEDs light-up rate and the number of intermediate beeps can
vary on different skin areas.
