Setting and Unsetting
Page
29
Additional Set/Unset Capabilities
Automatic Set/Unset
The LightSYS2 has the ability to define automatic system setting at a predefined time of a
day. An Set/Unset program automatically sets and unsets the system during your required
time intervals. When defining the automatic setting/unsetting program, you need to define
the following parameters:
Partition, Setting Mode
(Full/Partial),
Time
, and
Label
.
Set/Unset from your Wireless Keyfob
The system can be set using a wireless keyfob (If equipped with a wireless module
expansion). For detailed information regarding the keyfob operation consult with your
engineer .
Remote Set/Unset Using a Phone
If your LightSYS2 is equipped with the voice module you can perform setting/unsetting
operations and operate the system from a remote touch-tone phone by initiating a
telephone call to or from the system and interacting with voice menus that guide you
through your required remote operation. For detailed information refer to the
LightSYS
Voice Module Instructions
.
Emergency Alarms
Your keypad provides three sets of emergency keys, which can be pressed whenever the
police, fire department, or auxiliary assistance is required.
Police Emergency
Pressing
simultaneously, and for at least
two seconds, activates a police emergency alarm (panic
alarm).
Fire Emergency
Pressing
simultaneously, and for at least
two seconds, activates a fire emergency alarm.
Auxiliary Emergency
Pressing
simultaneously, and for at least two
seconds, activates an auxiliary emergency alarm.
The resulting annunciation, along with other system sounds is configurable. If your system
has been programmed to do so, it will communicate any or all of these alarms to the alarm
receiving centre for your installation. System programming also determines whether these
emergency alarms are audible and/or capable of being communicated to the alarm
receiving centre.