Setting and Unsetting
Page 24
To set a group (if your user code is assigned to more than one partition):
1.
Verify that the system is ready to set.
2.
Enter your user code, then the group letter (
,
,
,
),
then the partition number, and the group letter again
(
,
,
,
).
For example, to set group
C
, enter:
[Code]
[
for two seconds
]
[Partition No]
[
for two seconds
].
3.
To set another group, repeat above steps .
Note:
If your system supports Quick Setting, press the function key for two seconds
corresponding to the group(s) you want to set. The selected groups are set.
Setting With Faults in the System
If required, and defined by your engineer, all faults in the system may require confirmation
to enable the setting operation.
When trying to set the system with faults, the display will show the system faults.
Scroll through the list of faults using the
key. At the end of the list the following
question will appear: «
Override Fault?
» Use the
key to toggle the option to
Y
and
press
.
Keyswitch Setting
If your system is equipped with a special keyswitch, it can, with the twist of a key, be toggled
through full set and unset modes.
Setting in Blank Display Mode
To perform setting while the system is in blank display mode:
1.
Release the keypad by pressing [CODE] +
2.
Within 2 minutes time press:
For Part setting
For Part setting
