Rigol DG4062, Руководство пользователя

Страница: 33 / 238

Chapter 1 Quick Start RIGOL
DG4000 User's Guide
1-7
the USB storage device (a new folder named "Rigol" is created in the USB
storage device automatically).

Digital Oscilloscope: seamlessly interconnect with
RIGOL
DS1000E,
DS6000, MSO/DS4000, MSO/DS2000 and MSO/DS1000Z series digital
oscilloscopes; read and store the waveform displayed on the screen or
stored in the internal memory of the oscilloscope and then rebuild the
waveform losslessly.

Power Amplifier (Option): support
RIGOL
power amplifier (for example,
PA1011); users can perform on-line configuration of the power amplifier
as well as amplify the power of the signal and then output the signal.
3.
Menu Softkey
Correspond to the left menus respectively. Press any softkey to activate the
corresponding menu.
4. Page Up/Down
Open the previous or next page of the current function menu.
5. CH1 Output
BNC connector with 50Ω nominal output impedance.
When
Output1 is enabled (the backlight turns on), this connector output
waveform according to the current configuration of CH1.
6. CH1 Sync Output
BNC connector with 50Ω nominal output impedance.
When the sync output of CH1 is enabled, this connector outputs the sync
signal corresponding to the current settings of CH1 (refer to the introduction in
Sync).
7. Channel Control Area
CH1: used to select CH1. When CH1 is selected (the backlight turns on), users
can set the waveform and parameters of CH1.
CH2: used to select CH2. When CH2 is selected (the backlight turns on), users
can set the waveform and parameters of CH2.
Trigger1: in sweep or burst mode, it is used to trigger CH1 to generate a