8
Basic item (medium: E940)
Figure 8a
Main board
Trunk laterals
Figures 8a and 8b:
Laterals (A) ship in reverse position.
1. To reposition laterals:
• Loosen knobs (C) and slide blocks out
from under the clamp.
• Rotate blocks into correct position
and replace them under the clamp.
• Retighten knobs.
2. Extra set of laterals are installed in the
same manner
Use knobs (C) to adjust laterals laterally
and vertically, and to pivot blocks
approximately 30°.
Make sure laterals are clear of tray when
adjusting board angle.
Hip strap
Figure 8b:
Hip strap (B) attaches with
knobs (D). Slide up or down for best
location. Strap can be positioned above or
below laterals.
Board position
Figure 8b:
The main board slides
independently on a tubular steel track,
clamping with knob (E).
Board tilt
Figure 8c:
The angle of the board is
controlled by a handcrank (F). This sets
the board at any angle from horizontal to
vertical. Adjustments can take place at any
time once the user is secure.
The board position indicator (G) is a direct
angle indicator that is attached at the
pivot point.
Figure 8b
A
A
C
C
D
D
B
B
Figure 8c
E
E
F
F
G
G
B
B
