10
Figure 10a
Main board
Trunk laterals
Figures 10a and 10b:
Laterals (A) ship in reverse position.
1. To reposition laterals:
• Loosen knobs (C) and slide blocks out
from under the clamp.
• Rotate blocks into correct position
and replace them under the clamp.
• Retighten knobs.
2. Extra set of laterals are attached in the
same manner.
Use knobs (C) to adjust laterals laterally
and vertically, and to pivot blocks
approximately 30°.
Make sure laterals are clear of tray when
adjusting board angle.
Hip strap
Figure 10b:
Hip strap (B) attaches with
knobs (D). Slide up or down for best
location. Strap can be positioned above or
below support blocks.
Board tilt
Figure 10c:
The angle of the board is
controlled by a handcrank (F). This sets
the board at any angle from horizontal to
vertical. Adjustments can take place at any
time once the user is secure.
The board position indicator (G) is a
direct angle indicator that is attached at
the pivot point.
Figure 10b
C
C
D
D
Figure 10c
Basic item (large: E950)
F
F
G
G
A
A
A
A
B
B
B
B
