Riedel Bolero 2.0, Руководство пользователя

Страница: 73 / 130

73
Bolero 2.0 User Manual
RJ45
1 8
Pin AES67/Config LINK 1+2
1 D1+ / PoE+ (p) D1+
2 D1- / PoE+ (p) D1-
3 D2+ / PoE+ (n) D2+
4 D3+ / PoE+ (p) D3+
5 D3- / PoE+ (p) D3-
6 D2- / PoE+ (n) D2-
7 D4+ / PoE+ (n) D4+
8 D4- / PoE+ (n) D4-
Figure 112: RJ45
1Gbit Ethernet connection is necessary to operate the Bolero net.
Integrated/Artist Mode
·
The AES67/Config port is connected to the IP net which also hosts the Artist card.
·
The other two ports are not used. If they are connected anyway, an error will be issued and radio
transmission will be disabled.
Standalone/Link Mode
·
The AES67/Config port is primarily used as config port, i.e. to provide a connection to the Web-UI.
·
One can also directly attach up to two IO Devices (NSA-002A) to this port in a daisy chain as well.
·
Link-1 and Link-2 are used to interconnect the Antennas in a daisy chain ("open") or ring ("closed") topology.
o
A closed topology provides redundancy:
either
one cable in the ring can be detached without interrupting audio transmission.
o
In an open topology there's no more redundancy:
if a cable is detached, the affected nodes cannot be reached any more.
·
Link-1 on the local device must always be connected to Link-2 on the remote device (and vice versa).
·
CAT cables with a maximum length of 300 meters are supported.
·
With an External Power Supply (EPS), you can power up to 2 Antennas over Link-1 and Link-2 each (i.e. 4
Antennas in total).
·
It is not possible to use routers, switches or other standard IP devices.
Cable requirements: Cat-5e / Cat-6 or better (according to ISO/IEC 11801), S/FTP or better, up to 100 m.
Make sure ISO/IEC specification applies for the used length of the cable (in particular attenuation).
USB Type-C
A1 A12
B12 B1
Pin Description Pin Description
1 GND 7 Dn1
2 SSTXp1 8 SBU1
3 SSTXn1 9 VBUS
4 VBUS 10 SSRXn2
5 CC1 11 SSRXp2
6 Dp1 12 GND
Figure 113: USB Type-C