MAINTENANCE
S-SERIES PRIVATE USE SERVICE MANUAL
SEPTEMBER 2020
3- 16
32DSW02.F
2. Refer to
Figure 3-37.
Unscrew and remove T-Nut from saddle assembly.
FIGURE 3-37
FIGURE 3-41
3. Replace old or worn T-Nut with Kit (P/N 42052).
NOTE:
Before completing installation, ensure that T-Nut is oriented with the flat edge positioned in the horizontal
position. Refer to
Figure 3-38
.
4. Check lower arm for burrs and sharp edges. De-burr or file sharp edges if necessary before re-assembly
of saddle assembly.
5. Re-assemble in reverse order.
NOTE:
Refer to
Figure 3-39.
Delrin guide blocks are factory installed. Ensure that each guide block is
positioned towards the inside of the platform.
FIGURE 3-39
J. PUMP REPLACEMENT
CAUTION
This Ricon product is highly specialized. Maintenance and repairs must be performed by
an authorized Ricon service technician using Ricon replacement parts. Modifying or
failing to properly maintain the product will void warranty and may result in unsafe
operating conditions.
1. Disconnect power to lift.
2. Remove pump cover.
3. Lower lift to ground level with manual relief valve.
Note:
Lowering lift to ground with manual relief valve will ensure that all pressure is relieved from the hydraulic
system.
CAUTION
Wear safety glasses. Residual pressure may be in the hydraulic system, which can spray
fluid when first loosening the fittings. Be prepared with rags to catch fluid that spills.
4. Refer to
Figure 3-40.
Disconnect two breather lines from pump only.
