This SP allows you to confirm and reset the IPv4 address for Ethernet and a wireless LAN
(802.11b):
aaa.bbb.ccc.ddd
For example, if the 8-bit entry is "192.168.000.001" this is read "0C0A80001h"
002 IPv4 Subnet Mask
This SP allows you to confirm and reset the IPv4 subnet mask for Ethernet and a wireless
LAN (802.11b):
aaa.bbb.ccc.ddd
For example, if the 8-bit entry is "255.255.255.00" this is read "FFFFFF00h".
003 IPv4 DefaultGate
This SP allows you to confirm and reset the IPv4 default gateway used by the network for
Ethernet and wireless LAN (802.11b):
aaa.bbb.ccc.ddd
For example, if the 8-bit entry is "192.169.000.001" this is read "0C0A80001h"
006 DHCP
This SP code allows you confirm and change the setting that determines whether the IP
address is used with DHCP on an Ethernet or wireless (802.11b) LAN network.
[0 to 1/1/0]
0: Not used (manual setting)
1: Used
021 ActIPv4Add
This SP allows you to confirm the IPv4 address that was used when the machine started up
with DHCP. For example, if the the setting of the the IPv4 address is "0C0A80001h " this is
displayed as "192.169.000.001".
022 ActIPv4 SbNet
This SP allows you to confirm the IPv4 subnet mask setting that was used when the machine
started up with DHCP. For example, if the setting for the IPv4 subnet mask is "FFFFFF00H"
this is displayed as "255.255.255.000"
023 ActIPv4GateW
This SP allows you to confirm the IPv4 default gateway setting that was used when the
machine started up with DHCP. For example, if the setting for the IPv4 gateway is
"0C0A80001h" this is displayed as "192.168.000.001".
SP5-xxx Mode
315
5
Содержание Neptune-P1
