Ricoh Neptune-P1, Руководство по обслуживанию

Страница: 263 / 457

1. [

] or [

]> Select the desired position on the bar (from "Thick" to "Thin")
2. [OK]> "Programmed"
3. [Menu]> Standby
• These settings are used to adjust the fusing temperature and amount of pressure applied by the pressure
roller on the hot roller.
• Each notch (1 to 5) represents a "mode" (Mode 1 to Mode 5). These references to "modes" are used
in several SP codes below. Mode 1 is at the left end of the scale on the display, and Mode 5 is at the
right end.
• The modes for thicker paper are to the left of the "+" button and those for thinner paper to the right of
the "+" button.
• A thicker selection raises the fusing temperature and pressure applied by the pressure roller; a thinner
selection lowers the temperature and lowers the pressure for thinner paper.
• The settings can be done independently for paper fed from either the paper cassette or the bypass
tray.
1931 TTemp:HotRol Target Temp: Hot Roller
Sets the target fusing temperature of the hot roller. After you adjust these SP's, you must switch
the main power switch off and on.
Important: Modes "1" to "5" below refer to the paper type and thickness settings selected in
User Tools (see "Paper Thickness Default Selection" in this section).
1 Plain: Mode1
[120 to 220/195/5
o
C] 2 Plain: Mode2
3 Plain: Mode3
4 Plain: Mode4 [120 to 220/185/5
o
C]
5 Plain: Mode5 [120 to 220/175/5
o
C]
5. Service Tables
262
5