Ricoh Neptune-P1, Руководство по обслуживанию

Страница: 268 / 457

11 Film: Mode1
12 Film: Mode2
13 Film: Mode3
14 Film: Mode4
15 Film: Mode5
1937 LTemp:EnCtrl Low Temp Environment Detection Control
These SP's are used to modify fusing temperature control sequence in a low temperature
environment where room temperature is below the optimum room temperature of 20
o
C
(68
o
F).
Note
• At optimum room temperature, the machine should reach the target fusing temperature
within 2 min.
• If the hot roller does not reach the target fusing temperature within 2 minutes, the machine
issues SC542 (Fusing Temperature Warmup Error).
1 Low Temp Setting Low Temperature Setting
The machine monitors the time required for the hot roller temperature to reach the critical
temperature defined by this SP:
Copy Ready Temperature (SP1105) - This SP Value (Default: 20
o
C)
In a low temperature environment copying will not begin at the normal copy ready temperature.
[0 to 50/20/5]
2 LTemp Time Low Temp Time Setting
This SP sets the length of time within which the hot roller temperature should reach the target
temperature set with SP1937-1. If the hot roller does not reach the SP1937-1 temperature
within this time limit, the machine will not allow copying to start when the temperature reaches
the ready temperature.
[0 to 120/120/1 sec.]
3 Inch Temp Pressure Inching Start: Temperature
If the inching target temperature (set with SP1948) is higher than 65
o
C, inching will start when
the hot roller temperature reaches this target hot roller temperature. If the pressure roller
temperature is less than 60
o
C, inching will start at the ready (reload) temperature.
SP1-xxx Feed
267
5