Rice Lake BenchPro Series, Руководство по эксплуатации

Страница: 15 / 42

Configuration 11

SMA
Nci
3835
8213
ECr r
EH —
Protocol — determines the manufacturer output protocol or serial setting the scale is configured for;
check 3rd party software to confirm correct selection, if the scale is connected to a PC via the
BenchPro USB port, the USB HID protocol is automatically selected; USB HID settings are
1C19,0002
SMA — SMA Protocol (all models)Nci — 782X and 76XX family (all models)
3835 — NCI 3835 UPS worldship (models BP-XXXX-XXS only)
8213 — Toledo 8213 (models BP-XXXX-XXS only)
ECr — Electronic Cash Register (models BP-XXXS-XXR only)
EH — Models BP-XXXS-XXS only)

1200
2400
4800
9600
19200
38400
57600
Baud rate — match PC RS-232 setting to the setting of the scale; Check the PC Device Manager
setting through the control panel in port settings

7 even
7 odd
7 none
8 none
Data Bits and Parity — match PC RS-232 setting to the setting of the scale; Check the PC Device
Manager setting through the control panel in port settings

1
2
Stop bits — match PC RS-232 setting to the setting of the scale; Check the PC Device Manager
setting through the control panel in port settings

On
Off
Enable or disable the tare button

No
Yes
Gravity Compensation — see Section 3.4 on page 12 for detailed information
No - deactivated, calibrate scale with known accurate calibration weights
Yes - View original calibration gravity and modify local gravity settings

Off
On
Manufacturing mode only; do not use; not not adjust

lb
lb:oz
oz
kg
g Units of Measure — turn on and off units of measure; Applicable settings are dependant on the
model of scale purchased; see
Section 1.4 on page 5 for available selections; Most models have a
minimum of two units of measure turned on. To avoid incorrect weight being displayed or
transmitted to the PC, only have the applicable units of measure turned on.

150 kg Capacity — defines the maximum capacity of the scale and determines the weight value to be used;
• When selecting lb, the calibration weight used must be in lb
• When selecting kg, the calibration weight used must be in kilograms.
NOTE: See Section 1.4 on page 5 for capacity selections on each model. Do not select
capacities other than those indicated by the manufacturer,

Off
2rnG
3rnG
2intvl
3intvl
Configure the unit for multi-range or multi-interval on select models of the BenchPro Series
Off - unit displays in single range
2rnG - displays weight in multi-range mode dual range
3rnG - displays weight in multi-range mode triple range
2intvl - displays weight in multi-interval mode dual range
3intvl, - displays weight in multi-interval mode triple range

-- Calibration — see Section 4.0 on page 14 for detailed information on calibration of the scale

RAM
ROM
DIV-A
DIV-O Diagnostic menu — used to troubleshoot scale operation. See Section 6.1 on page 34 for more
information on using the diagnostic menu.
RAM - if an error occurs, contact RLWS for a new PCB
ROM - If an error occurs, contact RLWS for a new PCB
DIV-A - Display internal counts after auto zero tracking
DIV-O - Display internal counts

— Done — exit the configuration menu, save settings and return to weigh mode
Bold indicates factory default setting.
Parameter Settings Description
Table 3-2. Service Settings (Continued)