Page
12
/
21
IV. GETTING STARTED
Before any intervention on product, ensure that product is disconnected form its
power source.
4.1- Unpacking
Remove product from its packaging.
Check that product and accessories are not damage
4.2- Connecting the evacuation hose
Screw a connector 1” (not supplied) onto the pump outlet/discharge port (see 3 in Fig.1).
4.3- Adjusting the floating switch
1. The float switch (6) enables the automatic start of the pump.
For example:
When the water rises to reach approximately
50cm
, the pump starts up.
When water level has lowered to approximately
5cm
, the pump will stop automatically.
2. By shortening the length of the cable between the pump and the float, it is possible to modify the
water heights that trigger starting and stopping of the pump.
3. To adjust the cut-in/cut-out height, fix the float switch cable to the float switch lock (5) provided
for this purpose, located at the top of the pump.
4. Adjust the cable to the required length
4.4- Start-up
Note: Before use, clear the outlet line
Observe and respect minimum water level and max delivery height
1. The pump must be in a vertical position: ensure that it is stable during operation.
2. Ensure that the float switch can move freely (allow at least 50cm around the pump).
3. The suction holes must never be obstructed. It is therefore preferable that the pump should never be
placed directly on the ground or on the bottom of the well, pond or vessel.
For example, use a brick to support the pump.
Warning
: to dry out premises (cellar draining for example) it will be necessary to place the pump
below floor level.
