11
Test Print
From the HOME Tab menu select New Ribbon
Set the dimensions of your project. Type in the
width
of the Ribbon you in-
stalled earlier , and select a
length, 10cm
is a good start.
Now Click the TEXT Tab and click
“Text”,
type a short message and click
“Ok”
Click on the
Corners
to adjust the size of the box
Now drag a
Clipart
image from the lower screen into the design space. You
can adjust the size just like you did with Text.
You are now ready to print, click the Print Tab.
Make sure the printer selected is the
Argox CP-3140
, then select a heat
setting of
12
and select
1 c
opy, then click
“Print”
The printer green light will start flashing but may take a couple of seconds
to start printing.
If you have any issues printing, please check through the instructions again
and read the hints and tips section.
