RHINO RAv2, Инструкция по эксплуатации

Страница: 18 / 20

18
Connection For Two Stage Unlocking Using Rhino Central Locking Kit
Pressing centre button unlocks driver’s door only. Pressing left button for 3 seconds unlocks all
doors.
Pressing centre button again locks all doors. (Like VT Commodore operation).
VEHICLES FITTED WITH AN INTERIOR LIGHT DELAY
IMPORTANT NOTE:Vehicles fitted with an interior light delay.
Vehicles fitted with an interior light delay require a diode to be added
to prevent the system giving a door ajar warning.
Please follow the wiring diagram below :
Interior light
DOOR DELAY
CIRCUIT
+12V
White wire
Place a diode here
RHINO
Door Switches
Connect Lock
Common wire to Pin
8 on CLK Control
Module.
Connect Boot Release
Wire to Pin 10 on CLK
Control Module.
To
Unlock
L U
To NC
To C/Locking Module
Note: Lock NO must be
connected to earth & Unlock NO
must be connected to 12V for
correct operation.
Note: When installing our Central
Locking Kit, fit only a DL102 slave
(2 wire) motor in the drivers door.
Interrupt the unlock wire of the
motor with wires as shown.
Door wire