RHINO RAv2, Инструкция по эксплуатации

Страница: 8 / 20

8
Overriding the Immobiliser
Programming
How to Program the Selectable Features
Your Rhino Security system incorporates the latest in high security & convenience features. It is possible to
customise your security system so that it suits your requirements perfectly. Detailed below is the full list of
programmable features that can either be turned on or turned off.
We have set, at the factory, the most common configuration chosen and these settings are listed in the
REGISTER Settings listed below. Once the desired features have been selected, the selection is permanently
retained in memory, even if power is removed.
To turn on or turn off any feature use the following procedure: eg
to activate door lock on ignition.
1. F
ind the REGISTER (1or 2) in which the feature is located. (E.g. door lock on ignition is located in
REGISTER 1).
2.
Set the vehicle up as described to access REGISTER 1, (all doors closed, turning ignition on last).
3.
After turning the ignition to on, immediately press the Left Button an equal number of times to the selected
feature’s code number (eg 3 times for door lock on ignition). Each press of the remote will be confirmed by
a flash of both the blinkers & the dash LED, a confirmation beep will also be produced.
4.
Turn the ignition to off.
5. The system will then confirm which features are activated via visual readout. If a feature is enabled the
LED & indicators will flash out its code corresponding to the number shown in the column “ Press Remote
This Many Times ”. The indicators in this example will flash once for arming beep on, then twice for disarm
beep on, and then three times for door lock on ignition now being on.
PROCEDURE:
This feature enables the owner to override their immobiliser in case they have lost their remote controls or
they have damaged them. You have the secure choice of over 63,000 possible codes. Refer to Register 2 of
the Programmable Feature section of this manual (page 8) on how to choose your own code.
This should
be done upon installation.
To enter your override code:
1. Open your driver’s door and sit in the car. The siren will sound this is normal.
2. Now turn the ignition from on to off an equal number of times to your first code digit (this is a number
you have chosen between 3 and 255).
3. Wait for the blinkers to flash once. (This occurs whether you have entered the correct number or not).
4. Now turn the ignition from on to off an equal number of times to your second code digit (this is a
number you have chosen between 3 and 255).
5.
The immobiliser will now disarm. You must start your car within 38 seconds; otherwise the
immobiliser will automatically rearm.
NOTE: Unless a remote control is learnt in, if you turn the ignition off, you will have to repeat this