10
PAT™ Past Alarm
Trigger Memory
13
SELECT
to replay
memory
After pressing the remote 13 times to enter this mode, turn
the ignition off. Your Rhino Alarm offers a unique memory
that stores the ten last reasons why the alarm was
triggered. This memory cannot be erased.
1 Beep, 1 Flash - Voltage Drop Alarm
2 Beep, 2 Flashes - Glass Break Alarm
3 Beep, 3 Flashes - Shock Sensor Alarm
4 Beep, 4 Flashes - Power Fail Alarm
5 Beep, 5 Flashes - Ignition Alarm
6 Beep, 6 Flashes - Aux Alarm
7 Beep, 7 Flashes - Door Alarms
8 Beep, 8 Flashes - Bonnet / Boot Alarm
If two previous alarms were recorded i.e. voltage drop and
shock sensor the LED will flash and the siren will beep once
for voltage drop, then no noise for 1 second then beep three
times for shock sensor.
The last memory heard is the
most recent alarm sector triggered.
Turn the ignition to
on to exit this mode.
Current Sense Override
15
ON
When this feature is on, the alarm will not trigger when a
sudden change in battery current is sensed.
NOTE: This will ONLY beep out the state of this feature i.e.
no other active features in the register will be beeped out.
I.e. if this feature is NOT on, then NO beeps will be heard.
Wireless Keypad Mode
18
OFF
When this feature is turned on then the Wireless Keypad
may be used to disarm the vehicle while still using the
standard factory remotes to lock and unlock the vehicle.
See the Wireless Keypad instructions for further details.
If this featured is turned on then a single beep will be
produced. If this feature is turned off then no beeps will be
heard.
Transformer Interface
19
OFF
When this feature is turned on then the Transformer module
may be interfaced to allow the user to arm and disarm their
vehicle via the factory remote control.
NOTE: If the Transformer module was supplied with the
unit, then this feature would have been turned ON by
default.
If this featured is turned on then a single beep will be
produced. If this feature is turned off then no beeps will be
heard.
Содержание RAv2
Страница 20: ...20...
