RFL Electronics RFL 9660, Инструкция по эксплуатации, Страница: 176 / 312

RFL 9660 RFL Electronics Inc.
April 24, 2007 13-23 (973) 334-3100
Command: +VCID=n Caller ID Selection
Values: n = 0, 1, or 2
Default: 0
Description: Enables Caller ID detection and configures the reporting and presentation of
the Caller ID data that is detected after the first ring. The reported data
includes the date and time of the call, the caller's name and number, and a
message. Set S0=2.
+VCID=0 Disables Caller ID
+VCID=1 Enables Caller ID with formatted data
+VCID=2 Enables Caller ID with unformatted data
+VCID=? Displays the allowed values
+VCID? Displays the current value
Command: +VDR=x, y Distinctive Ring Report
Values: x = 0, 1 Distinctive Ring report control. See description.
y = 0–255 Minimum ring interval in 100 ms units. See description.
Default: 0, 0
Description: Enables reporting of ring cadence information to the DTE and specifies the
minimum ring cadence that will be reported.
Report format is one line per silence period and one line per ring period. The
length of the silence period is in the form DROF=number in units of 100
ms<CR><LF>, and the length of the ring is in the form DRON=number in
units of 100 ms<CR> <LF>. The modem may produce a Ring event code
after the DRON message if enabled by the y parameter. The y parameter
must be set to a value equal to or smaller than the expected ring cadence in
order to pass the report to the DTE.
+VDR=0,N/A Disables Distinctive Ring cadence reporting.
+VDR=1, 0 Enables Distinctive Ring cadence reporting. Other call
progress result codes (including RING) are reported as
normal.
+VDR=1, >0 Enables Distinctive Ring cadence reporting. RING result
code is reported after falling edge of the ring pulse (after the
DRON report).
+VDR=? Displays the allowed values.
+VDR? Displays the current value.
Command: #CBAn Callback Attempts
Values: n = 1–255
Default: 4
Description: Sets the number of callback attempts that are allowed after passwords have
been exchanged between modems.
Command: #CBDn Callback Delay
Values: n = 0–255
Default: 15
Description: Sets the length of time (in seconds) that the modem waits before calling back
the remote modem.