RFL Electronics RFL 9660, Инструкция по эксплуатации, Страница: 166 / 312

RFL 9660 RFL Electronics Inc.
April 24, 2007 13-13 (973) 334-3100
Command: %A Adaptive Answer Result Code Enable
Values:
n = 0 or 1
Default:
0
Description: The %A command controls whether the DATA or FAX result codes will be sent by
the modem. The modem must be in fax mode for this command to work. Also, the
modem must be set to
+FAA=1 , which enables the modem to distinguish
between a fax and a data call. When these commands are enabled, the modem
sends DATA to the computer when it detects data tones and FAX when it detects
fax tones. These strings are used by some servers to select the appropriate
communication program.
%A0 Disables adaptive answer result codes.
%A1 Enables adaptive answer result codes.
Command: %B View Numbers in Blacklist
Values:
N/A
Description : If blacklisting is in effect, AT%B displays the numbers for which the last call
attempted in the previous two hours failed. In countries that do not require
blacklisting, the
ERROR result code appears.
Command: %Cn Data Compression Control
Values:
n = 0 or 1
Default:
1
Description:
%C0 Disable V.42bis/MNP 5 data compression.
%C1 Enable V.42bis/MNP 5 data compression.
Command : %DCn AT Command Control
Values:
n = 0 or 1
Default:
0
Description:
%DC0 The modem responds to AT commands.
%DC1 The modem ignores AT commands.
Note: The modem will respond to AT%DC for 10 seconds after power-up.
Command: %En Fallback and Fall Forward Control
Values:
n = 0, 1, or 2
Default:
2
Description:
%E0 Disable fallback and fall forward.
%E1 Enable fallback, disable fall forward.
%E2 Enable fallback and fall forward.
Command : %Hn Direct Connect Enable
Values:
n = 0, 1
Default:
0
Description:
%H0 Sets callback security to normal operation.
%H1 All callback security calls will be direct connect regardless of whether the
password or phone number has the - character.
Command: %Rn Cisco Configuration
Values:
n = 0, 1
Default:
0
Description:
%R0 Disables Cisco configuration.
%R1 Sets E0 , Q1 , &D0 , \N0 , $SB9600 , and %S1 for operation with a Cisco
router.