RFL Electronics RFL 9660, Инструкция по эксплуатации, Страница: 112 / 312

RFL 9660 RFL Electronics Inc.
August 18, 1998 5-15 (973) 334-3100
PT nnnn - Inactive Period, Port Selected
This command sets the inactive period timer for port selection. If the RFL 9660
connects to a port and this period passes with no data going through the port, the
RFL 9660 disconnects from the port. The default setting is 600 seconds (ten
minutes), but it can be set anywhere from 20 seconds to 32,000 seconds (8 hours,
53 minutes, 20 seconds).
Format: CONFIG> PT space, desired value [ENTER]
Example: CONFIG> PT 600 [ENTER]
The example above sets the timer to 600 seconds, or ten minutes. This timer
prevents the RFL 9660 from remaining connected to one port when it is not being
used. This would prevent access to other devices. The timeout setting is the same
for all ports.
PM nnnn - Inactive period, menu mode
This command sets the inactive period timer for line connection. If the RFL 9660
connects to either a local or remote terminal and this period passes with no
commands being received, the RFL 9660 disconnects from the terminal. The
default setting is 600 seconds (ten minutes), but it can be set anywhere from
20 seconds to 32,000 seconds (8 hours, 53 minutes, 20 seconds).
Format: CONFIG> PM space, desired value [ENTER]
Example: CONFIG> PM 600 [ENTER]
The example above sets the timer to 600 seconds, or ten minutes. This timer is also
triggered after the PT timer has timed out. For example, if the RFL 9660 is
connected to a port and no data passes through the port during the port inactive
period, the port will be deselected. Then, if no commands pass during the terminal
connection menu inactive period, the RFL 9660 will disconnect.
This feature prevents the RFL 9660 from remaining connected inadvertently and
preventing access to other equipment requesting service, or other remote terminals.