RFL Electronics RFL 9660, Инструкция по эксплуатации, Страница: 111 / 312

RFL 9660 RFL Electronics Inc.
August 18, 1998 5-14 (973) 334-3100
PP nn - Period Awaiting Password
This command sets the amount of time the RFL 9660 will wait for a password when
password protection is enabled. The default setting is 28 seconds, but it can be set
anywhere from 5 seconds to 99 seconds (1 minute, 39 seconds).
Format: CONFIG> PP space, desired value [ENTER]
Example: CONFIG> PP 10 [ENTER]
The example above tells the RFL 9660 to hang up if there is no data activity for
ten seconds after the "Please enter password" prompt appears.
PA nn - Silence Before Deselect Code
This command sets the silence period before the deselect code may be entered. The
deselect code is used to disconnect the RFL 9660 from a port. This value is used with
the PB and CC values to make up the deselect sequence. The default setting is
one second, but it can be set anywhere from 1 to 99 seconds.
Format: CONFIG> PA space, desired value [ENTER]
Example: CONFIG> PA 5 [ENTER]
The example above tells the RFL 9660 to monitor the incoming data for a five-second
pause period. Once this pause period is detected, the RFL 9660 looks for the
deselect code. If the deselect code is not received after the deselect silence period
has elapsed, any data received by the RFL 9660 is passed on to the DTE.
PB nn - Silence After Deselect Code
This command sets the silence period after the deselect code. The deselect code is
used to disconnect the RFL 9660 from a port. This value is used with the PA and CC
values to make up the deselect sequence. The default setting is one second, but it
can be set anywhere from 1 to 99 seconds.
Format: CONFIG> PB space, desired value [ENTER]
Example: CONFIG> PB 5 [ENTER]
The example above tells the RFL 9660 to monitor the incoming data for the deselect
sequence. After the deselect code is accepted, data will need to be paused again. If
this does not happen, the data is still passed on to the DTE, and the deselect
command is canceled.