RFL Electronics RFL 9660, Инструкция по эксплуатации, Страница: 116 / 312

RFL 9660 RFL Electronics Inc.
August 18, 1998 5-19 (973) 334-3100
If you made changes and then use the "Q" command below to exit the configuration
command mode without saving the changes first, the changes you made are active
but not saved. If you turn off the RFL 9660 and then turned back on, it will default to
the previous parameter settings.
CA x - Enable Port Selection By Number
This command allows port selection by port number. Two settings are possible: Y
(yes) and N (no). The default setting is "Y."
Format: CONFIG> CA setting [ENTER]
Example: CONFIG> CA Y [ENTER]
The example above sets this command to "yes." This will allow ports to be selected by
port number or port label. If it is set to "no," ports can only be selected by label.
Q - Quit programming mode without saving changes
Use this command to exit the configuration command mode and return to your regular
prompt.
Format: CONFIG> Q [ENTER]
If you made changes to the program and wish to save them, use the "CS" command
on page 5-18 before quitting. If you made changes and are not sure if you want to
save them, use the "S" command described below to view the current settings.
All command settings are accepted and implemented when entered. However, they
are not written to non-volatile memory unless you use the "S" command. If you make
changes and don't save them, the values in non-volatile memory are used as the
default settings the next time the RFL 9660 is powered up.
Once you have left the configuration command mode, the configuration command
prompt ( "CONFIG>" ) will be replaced by your normal prompt ("REMOTE>" or
"LOCAL>").
S - Show Current Selections
This command displays a list of the current active super-user command selections.
Format: CONFIG> S [ENTER]
A list similar to the one in Figure 5-6 will appear. Only the command code is shown
with the current value next to it, so it will be helpful to have this manual available when
displaying the list.
# Password Use Callback String