RexXer Tuning GmbH
l Astheimer Str. 41 l DE - 65428 Rüsselsheim l Fon: +49 (0) 6142 / 793971-203 l Fax: +49 (0) 6142 / 793971-80
www.rexxer.eu
© by RexXer ECU Tuning
8
Operation of the RexXer EVO
„User“
WARNING!
Before using this product, first read this manual carefully and
retain it for future reference. To avoid electrical shock, do not open the
case when the tool is connected. Refer any required servicing of product
to RexXer ECU Tuning only!
Makes sure that the battery of your motorcycle is fully loaded. In
models where the light burns continuously during the programming
process, you can optionally use a battery charger. But make
absolutely sure that this is a linear charger, which never builds up
voltage spikes. The RexXer EVO User could be damaged.
Note:
When delivered
the RexXer EVO User is ready for service and can
be used immediately. The connection with the supplied software is in this
step optional. If you want to connect the RexXer EVO User later, you
need an active internet connection.
The RexXer EVO User can be delivered in 2 different variants:
1)
Pre-installed with the corresponding Tuning-Mapping(s)
2)
Without the corresponding Tuning-Mapping(s)
Please refer to your delivery note which variant applies to you.
In most cases the RexXer EVO User will be delivered empty, without
pre-installed Tuning-Mapping. The reason is, that there is not every
Tuning-Mapping compatible. We often need the readout Original-
Mapping from motorcycle to create the Tuning-Mapping.
The following describes the procedure of both variants.
1) Connect the supplied serial interface cable to the RexXer EVO User.
Please not connect the USB cable in addition to the RexXer EVO
User*!
2) Connect the other end of the serial interface cable to the diagnostic
connector/service
plug
(OBD)
of
your
motorcycle.
3) Now connect the positive terminal of the battery with the red-coded
and the negative terminal with the black-coded alligator clip (not
available/necessary for all interface cables).
