REXROTH Sytronix FcP 5020, Руководство по эксплуатации

Страница: 179 / 204

8 Operation
8.1 General Information
● During operation, ensure compliance with the described environmental
conditions.
● Monitor noises, temperature and vibration at the machine at all times.
● After some operating time, check the hydraulic fluid in the tank for bub‐
ble or foam formation at the surface.
Changes in operating speed, temperatures, increasing noise or
power consumption are an indication of wear or damage on the
machine or the FcP system. In case of deviations, please proceed
according to chapter 14 "Troubleshooting" on page 187 .
8.2 Modes
8.2.1 Standby / Parameter Mode
Standby / Parameter mode is automatically reached after every restart, if no
error was generated or identified during ramp-up. You can modify all configu‐
ration parameter through control panel, communication or engineering soft‐
ware.
If the standard parameterization is insufficient for your application,
contact the responsible Bosch Rexroth account manager.
8.2.2 Operating Mode
Parameter Setting range Description
E0.01
0: Panel
1: Multi-function digital input
2: Communication
Frequency converter control command
Tab. 8-1: Operating mode
● [E0.01] = 0, operating mode can be started by pressing the <Run> but‐
ton on the operating unit.
● [E0.01] = 1, operating mode is triggered by the "High" signal level at the
"X1" digital input.
● [E0.00] = 2, operating mode can be started via remote control from En‐
gineering Software.
8.2.3 Error Mode
When an error or warning occurs, please terminate the error cause, then the
error/warning massage can be removed from display by following there ways:
●
Press [Stop] button
● Set "X2" high level
DOK-SYTROX-FCP5020****-IT01-EN-P Bosch Rexroth AG 177/201
Frequency-controlled pump drive system Sytronix FcP 5020
Operation