REXON SM2509R, Инструкция по эксплуатации

Страница: 9 / 32

6
NOTE: This tool is accurately adjusted
before shipping from the factory. Check
the following accuracy and readjust them if
necessary in order to obtain the best results
in operation.
BEVEL STOP ADJUSTMENT
90° (0°) Bevel Adjustment (Fig. 11)
1. Loosen bevel locking handle (1) and tilt
the cutting arm completely to the right.
Tighten the bevel locking handle (1).
2. Place a combination square (2) on the
miter table (3) with the ruler against the
table and heel of the square against the
saw blade.
3. If the blade is not 90° square with the
miter table, loosen the bevel locking
handle (1), tilt the cutting head to the
left, loosen the lock nut (4) and turn
the adjustment bolt (5) in or out with
a 10 mm wrench until the blade is
square with the table. Once alignment
is achieved, tighten the lock nut (4) to
secure the adjustment bolt (5).
4. Tighten the bevel locking handle (1)
after alignment is achieved.
90° Bevel Pointer Adjustment (Fig. 12)
1. When the blade is exactly 90° (0°)
to the table, loosen the bevel pointer
screw (1) using a Phillips screwdriver.
2. Adjust the bevel pointer (2) to the “0”
mark on the bevel scale and retighten
the screw (1).
Setting the tool
WARNING! To avoid injury from an
accidental start, make sure the switch is
in the OFF position and the plug is not
connected to the power source outlet.
45° Bevel Stop Adjustment (Fig. 12, 13)
1. Loosen the bevel locking handle (4),
fully extend the sliding fence completely
to the left, and tilt the cutting arm
completely to the left. (Fig. 13)
2. Set the miter angle to zero degree. Pull
the bevel detent pin (3) toward the front
of the machine. (Fig. 12)
NOTE: When retracting the bevel detent
pin, it may be required to shift the
cutting arm to the left.
3. Using a combination square, check to
see if the blade is 45° to the table.
4. If the blade is not at 45° to the miter
table, tilt the cutting arm to zero degree,
loosen the lock nut (5) and turn the
bolt (6) in or out accordingly.
5. Tilt the cutting arm back to the left and
recheck alignment.
6. Repeat above steps until the blade
is 45° to the table. Once alignment is
achieved, tighten the lock nut (5) to
secure the bolt (6).
33.9° Bevel Adjustment (Fig. 12, 13)
1. Set the miter angle to zero degree. Fully
extend the left sliding fence.
2. Loosen the bevel locking handle (4 -
Fig. 13) and tilt cutting arm to the 33.9°
left bevel positive stop by pushing in on
the bevel detent pin (3 - Fig. 12) toward
the rear of the machine.
3. Using a combination square, check to
see if the blade is 33.9° to the table.
4. To adjust, turn the screw (7) in or out
with a wrench until the blade is 33.9° to
the table.
MITER SCALE (FIG. 14)
The sliding compound miter saw scale can
be easily read, showing miter angles from
0° to 50° to the left and right. The miter saw
table has positive stops at most common
angle settings at 0°, 15°, 22.5°, 31.6°, and
45°. These positive stops position the blade
at the desired angle quickly and accurately.
Follow the process below for quickest and
most accurate adjustments.