REXON SM2509R, Инструкция по эксплуатации

Страница: 14 / 32

11
SLIDING FENCE (FIG. 28)
1. Unlock the fence cam locking lever (1)
by pushing it toward the rear of the
machine.
2. Extend the fence (2) by sliding it out.
Lock the fence cam locking lever (1) by
pulling it in toward the fence.
NOTE: When transporting the saw,
always secure the sliding fence in the
collapsed position and locking it.
REMOVING OR INSTALLING THE
SLIDING FENCE (FIG. 29)
WARNING! The sliding fence must be
extended when making any bevel cut.
Failure to extend the sliding fence will
not allow enough space for the blade
to pass through which could result in
serious injury. At extreme miter or bevel
angles the saw blade may also contact
the fence.
Removing
1. Unlock the fence cam locking lever (1)
by pushing it out toward the rear of the
machine.
2. Align the slot (2) with the bolt (3) in the
rear of the fence, and then lift up the
sliding fence to remove it from the saw.
Installing
1. Align the slot (2) with the bolt (3) in the
rear of the fence to place the sliding
fence onto the miter saw fence.
2. Slide the nut (4) to align the nut (4) with
the slot (5).
3. To lock the sliding fence, push the cam
locking lever (1) in toward the front of
the machine.
SLIDING CARRIAGE SYSTEM (FIG. 30)
1. For chop cutting operations on small
workpieces, slide the cutting head
assembly completely toward the rear of
the unit and tighten the sliding carriage
lock knob (1).
2. To cut wide boards up to 318 mm, the
sliding carriage lock knob (1) must be
loosened to allow the cutting head to
slide freely.
QUICK-CAM LOCKING LEVER
OPERATION (FIG. 31)
If miter angles required are NOT one of
the nine positive stops, the miter table can
be locked at any angle between these
positive stops by using the quick-cam
locking lever.
1. Unlock the miter table by lifting up on
the quick-cam locking lever (1).
2. While holding the positive stop locking
lever (2) up, grasp the miter handle (3)
and move the miter table left or right to
the desired angle.
WARNING!
●
DRY RUN - It is important to know
where the blade will intersect
with the workpiece during cutting
operations. Always perform a
simulated cutting sequence with the
power tool switched OFF to gain an
understanding of the projected path
of the saw blade. At some extreme
angles, the left side fence might
have to be removed to ensure proper
clearance prior to making the cut.
●
The left side sliding fence must
be removed when making any left
bevel angle cuts greater than 33.9°
in combination with any right or left
miter angle. This fence must also be
removed whenever a 45° bevel angle
is desired with a miter angle greater
than 31.6°.
WARNING! To reduce the risk of injury,
return carriage to the full rear position
after each crosscut operation.