REXON SM2509R, Инструкция по эксплуатации

Страница: 18 / 32

15
Removing the Blade (Fig. 41, 42, 43, 44)
1. Unplug the saw from the outlet.
2. Raise the cutting head to the upright
position. Slide the cutting head
assembly completely toward the rear of
the unit and tighten the sliding carriage
lock knob.
3. Loosen the cover plate screw (2) with a
Phillips screwdriver. (Fig. 41)
4. Raise the lower blade guard (1) to the
uppermost position. (Fig. 42)
5. Rotate the cover plate (3) back to
expose the arbor bolt (4).
6. Place the provided blade wrench over
the arbor bolt (4).
7. Locate the arbor lock button (5) below
the trigger switch handle. (Fig. 43)
8. Press the arbor lock button (5), holding
it in firmly while turning the blade
wrench clockwise. This will engage
the arbor lock allowing the arbor bolt
to be loosened with the blade wrench.
Continue to hold the arbor lock
button (5), while turning the wrench
clockwise to loosen the arbor bolt.
9. Remove the arbor bolt (4), the outer
blade collar (6), the blade (7) and the
reducer (8). Do not remove the inner
blade collar. (Fig. 44)
NOTE : Pay attention to the pieces
removed, noting their position and
direction they face. Wipe the blade collars
clean of any sawdust before installing a
new blade. Also, the 255 mm blade has
a 25.4 mm arbor hole with a 15.95 mm
reducer (8) to mount onto the saw.
Changing Blades
WARNING! Do not use a blade larger
than 255 mm in diameter. To avoid injury
from an accidental start, make sure
the switch is in the OFF position and
the plug is not connected to the power
source outlet.
Installing the Blade (Fig. 41, 42, 43, 44)
Unplug the miter saw before changing/
installing the blade.
1. Install a 255 mm blade with a 25.4 mm
arbor hole with a 15.95 mm reducer
making sure the rotation arrow on the
blade matches the clockwise rotation
arrow on the upper guard, and the blade
teeth are pointing downward.
2. Place the reducer (8) and the blade (7)
onto the arbor. Place the outer blade
collar (6) onto the arbor and against
the blade. Thread the arbor bolt (4)
conterclockwise onto the arbor. (Fig. 44)
IMPORTANT: Make sure the flats of the
blade collars are engaged with the flats
on the arbor shaft.
3. Place the blade wrench on the arbor
bolt (4).
4. Press the arbor lock (5), holding
it in firmly while turning the blade
counterclockwise. When arbor lock (5)
engages, continue to press it in while
tightening the arbor bolt securely.
(Fig. 43)
5. Lower the blade guard (1) and rotate
the cover plate (3) back to its original
position until the slot in the cover plate
engages with the cover plate screw (2).
(Fig. 42)
6. Tighten the cover plate screw (2) with a
Phillips screwdriver. (Fig. 41)
7. Verify that the operation of the blade
guard (1) does not bind or stick.
8. Be sure the arbor lock (5) is released so
the blade turns freely. (Fig. 43)
WARNING!
●
To avoid injury, never use the saw
without the cover plate secure in
place. It keeps the arbor bolt from
falling out if it accidentally loosens,
and helps prevent the spinning blade
from coming off the saw.
●
Make sure the collars are clean and
properly arranged. Lower the blade
into the lower table and check for any
contact with the base or the miter
table by spinning the blade manually.