10
BASIC MITER SAW OPERATIONS
1. It is recommended to use the clamp to
hold the workpiece firmly. Two holes are
provided for the clamp.
2. Always position the workpiece against
the fence. Any piece that is bowed or
warped and cannot be held flat on the
table or against fence may trap the
blade and should not be used.
BODY AND HANDS POSITION (FIG. 26)
Never place hands near cutting area. Keep
hands outside the “No-Hands Zone” which
includes entire table and is labeled by “No
Hands” symbols.
TURNING THE SAW ON (FIG. 27)
This miter saw is equipped with an ON/OFF
trigger switch (1). When the trigger switch is
squeezed, the miter saw will be turned on.
NOTE:
●
To make the ON/OFF switch childproof.
Insert a padlock (not provided), or chain
with padlock, through the hole (2) in the
trigger switch, locking the tool’s switch,
preventing children and other unqualified
users from turning the machine on.
●
The miter saw is equipped with an
electric blade brake. When the trigger
switch is released, the blade brake will
stop the blade within approximately
6 seconds.
Check that the power supply and outlet
used is in accordance with your miter
saw. Have a look at the rating plate of the
motor or the rating on the miter saw. Any
changes should always be carried out by a
qualified electrician.
USING AN EXTENSION LEAD
The use of any extension lead will cause
some loss of power. To keep this to a
minimum and to prevent overheating and
motor burn-out, ask advice from a qualified
electrician to determine the minimum wire
size of the extension lead. If the power
cable is broken, repair service is available
at your nearest service center.
NOTE:
We highly recommend that you bolt
this miter saw securely to a work bench to
gain the maximum stability of your machine.
Ensure that the machine is always fixed to
a bench whenever possible.
1. Locate and mark the four bolt holes on
the bench.
2. Drill the bench with an Ø10 mm drill bit.
3. Bolt the miter saw on to the bench with
bolts, washers and nuts. Note that these
fasteners are not supplied with the
machine.
Connecting to the Power Supply
WARNING! Avoid contact with the
terminals on the plug when installing
(removing) the plug to (from) the power
supply outlet. Contact will cause a
severe electrical shock.
Mounting the tool
WARNING! To avoid injury from
materials being thrown, unplug saw
to avoid accidental starting, and then
remove small materials.
Operating the tool
WARNING!
Never connect the plug to the
power source outlet until all installations
and adjustments are completed and you
have read and understood the safety
and operational instructions.
Содержание SM2509R
