16
GENERAL MAINTENANCE
Occasionally use a cloth to wipe off chips
and dust from the machine. And oil the
rotary parts once a month to extend the tool
life. Do not oil the motor.
BRUSH INSPECTION (FIG. 45)
Check the motor brushes after the first
50 hours of use for a new machine or after
a new set of brushes have been installed.
After the first check, examine them every
10 hours of use.
When the carbon is worn to 6 mm in length
or if the spring or shunt wire is burned
or damaged, replace both brushes. If
the brushes are found serviceable after
removing, reinstall them.
To inspect or replace brushes, first unplug
the saw. Then remove the black plastic
cap (1) on the side of the motor (2).
Remove the cap cautiously, because it is
springloaded. Then pull out the carbon
brush (3) and replace. To reassemble,
reverse the procedure. The ears on the
metal end of the assembly go in the same
hole the carbon part fits into. Tighten the
cap snugly, but do not overtighten. Repeat
for the carbon brush located on the other
side of motor.
NOTE:
To reinstall the same brushes, first
make sure the brushes go back in the way
they came out. This will avoid a break-in
period that reduces motor performance and
increases wear.
WARNING! For your own safety, turn the
switch off and remove the plug from the
power source outlet before maintaining
or lubricating your miter saw.
Maintenance
Содержание SM2509R
