Band knife machine R750/R1000 – Instruction manual
Page
61 / 89
FPUH Rexel s.c.
ul. Radziwoja 11, 61-057 Poznań
tel.: +48 61 87 68 946
www.rexelpoland.com
Steps to replace sharpening stones (pic. 7):
Uninstall sharpening device from machine removing or opening any
covers on the way.
Block the axis of sharpening stone (7) by screwdriver and unscrew the
nut (8). Replace the stones.
Tighten the nuts. Install sharpener on the shaft (6).
Make a test sharpening and adjust the gap between the band and the
sharpening stones (look: Band knife sharpening).
8.5.
C
UTTING BAND REPLACEMENT
Band knife should be replaced in case of:
•
High wear of the band (if the width of a band knife is about 5 mm it should
be replaced on a new one).
•
Cracked band.
Great influence of the work of a band knife machine, especially on the level of
noise, vibration and machine long-lasting has a way of operation.
The cutting band knife length must be precisely sustained (see: Technical
specification). Allowed length of a band for each type of our Band cutting
machines is +/- 5 mm.
Steps to replace the cutting band:
The cutting band may be replaced by a single worker wearing personal protective
equipment, ie:
•
Protective gloves
•
Goggles
•
Protective clothing
NOTE: The machine must be switched ON when changing the band!
In order to replace the cutting band:
Switch the machine to the service mode with the "SERVICE" button
on the control cabinet.
Press the "EMERGENCY STOP" button (1) on the operator panel,
Lift up the machine support with the help of handles (pic.1 p.33),
