Revere 45-CC2V, Руководство по обслуживанию, Страница: 82 / 226

INLET CHECK VALVE
1. Using clean, dry shop air, inflate the compartment to 2.0 psig.
2. Spray a solution of soapy water on top of the valve. Apply solution slowly to generate the least
amount of bubbles possible.
3. Monitor and check for generation of new bubbles. The inlet check valves should be airtight and
not allow new bubbles to form.
4. The inlet check valve will “pass inspection” if no bubbles form.
GAS CYLINDER AND INFLATION VALVE
Warning:
A fully charged cylinder can become a lethal projectile if discharged to
atmosphere when not fitted with a diffuser cap. Always fit the diffuser caps to
the cylinder valve outlets when handling a fully charged cylinder.
Weight
Coastal Compact 4: Remove the diffuser caps from the cylinder to obtain an accurate current weight.
Check current weight of the cylinder against the total weight marked on the
cylinder label. Renew or recharge the cylinder if the current weight is less than
98% of the marked total weight.
Coastal Compact 2: Remove the diffuser caps from the cylinder to obtain an accurate current weight.
Weight the cylinder with the inflation valve attached. Do not remove inflation
valve. The actual gross weight of the cylinder plus valve assembly must be at
least 100 grams greater than the Minimum Gross Weight marked on the cylinder.
If not, replace the cylinder. The Coastal Compact 2 cylinders cannot be
refilled. They are disposable after being discharged.
After weighing, fit diffuser caps back onto the cylinder.
Note: Diffuser caps must ALWAYS be fitted to a cylinder when it is not fitted with an
inflation hose.
Recharging
The CO
2
gas used for recharging must have a maximum moisture content of .015 %.
See Chapter 8 – Assembly for recharging details.
May 29/13
4 - 16
9102