Revere 45-CC2V, Руководство по обслуживанию

Страница: 25 / 226

SERVICE BULLETIN NO. 09/16
Sept 20/16
9102
SB - 15
5323 Highway Avenue
Jacksonville, FL 32254
(T) 904.503.9733
(F) 904.503.9719
ACCESSORIES:
1. Resetting Tool 90-038
2. Circlip Tool LT 14 U
3. Grease Aero Shell 14
4. Silicone Grease 4 Compound
5. Protection Cap for 3/8” outlet 005-661
6. 30mm open spanner Commercial
7. 24mm open spanner Commercial
8. 30mm open tool for torque spanner 14-151
8. Tool for release top 99-050
8. PRV OTS-45 INSTALLATION
The OTS 45 relief valve consists of 4 main elements:
1. Valve body section.
2. Nut.
3. Washer / washer with closing cap.
4. O-ring.
The valve parts are produced from Acetal Copolymer (1+2+3)
The seal/o-ring (4) is made of silicone rubber.
INSTALLATION:
When the nut (2) is in position inside the tube, the washer (3) is placed over the hole with the
o-ring (4) in the center.
Cutting hole in the fabric: 22 mm
IMPORTANT
The grip rings of the washer (3) must be placed towards the fabric.
The valve body (1) is screwed into the nut through the fabric by hand, before any tools are used. The
valve is tightened to the raft and finally by torque tool. Depending of the fabric – reinforcement can be
necessary. Check the color code of the valve for the right pressure.
TIGHTENING:
To tighten the valve use a 32 mm top spanner/torque tool.
Tightening torque: 6 – 8 Nm