32
10. Installation
Before firmly installing the outdoor sensor, ensure that the weather station receives the radio signal of the
outdoor sensor without problems. The radio range between the outdoor sensor and the weather station is up
to 100m at a free line of sight. Walls, metal-coated insulating glass or other influences can strongly reduce this
range. Therefore, first check for proper reception of the measuring data before installing the outdoor sensor.
• The outdoor sensor can be attached to the wall on a nail, screw or hook using an opening on the rear. Ensure that no
present electrical or water lines are damaged by installation. The delivery also includes a suction cup to attach the
outdoor sensor to smooth surfaces (e.g. glass). The surface must be smooth, clean and dry.
The outdoor sensor is suitable to be used in a protected outdoor area. It should be placed so that it is not subject to
direct solar irradiation, because the measured values will be incorrect otherwise. Precipitation on the outdoor sensor
also leads to incorrect temperature measurement because the casing cools off. Never immerse or submerge the out-
door sensor in water; it would be destroyed! We therefore recommend careful selection of the site of installation for the
outdoor sensor to measure the correct temperature (and humidity). If the outdoor sensor is installed on a house wall, we
recommend installation on the North side, since most prerequisites are met there.
• The weather station can be put up on a level, stable surface with the base integrated in the back. Unfold the base for
this. Protect valuable furniture surfaces from scratches with suitable pads. The weather station can be attached to the
wall on a nail, screw or hook using an opening on the rear as well.
Select a location as operating site that is not in the sun or next to a radiator. This will falsify the temperature or humidity
display.
11. SETUP Settings
Change the values or symbols with the buttons “+” or “-”.
Keep the respective button pressed for quick adjustment.
Push the “SET” button to save the set value and switch to the next setting.
If you do not push any button for approx. 30 seconds, the settings made until then are saved and setting mode is
left.
The button “SNOOZE/LIGHT” leaves the setting mode at any time.
• The weather station must be in normal mode. To enter SETUP mode, push and hold the button “SET” for approx. 3 sec-
onds, until the setting (12H or 24H) flashes in the display.
