Renfert Basic Master, Инструкция по эксплуатации

Страница: 17 / 68

- 17 -
EN
15. Troubleshooting Guide
Problem Possible cause Corrective action
No air and no
abrasive.
• Blasting nozzle blocked at
the hand-piece.
• Foot switch connecting
lines kinked.
• Switch set to an intermedi -
ate position (only on the
2-tanks version).
• Unscrew the nozzle from the hand-piece and blow it out.
• With the nozzle removed, blow out the blasting hose by acti
-
vating the foot pedal.
• Inspect/correct the connection lines.
• Turn the switch until you feel it click into place.
Only air, no or
very little abra-
sive.
• The dosage nozzle in the
mixing chamber is blocked
due to contaminated or
moist sand.
• Mixing chamber filter com -
bination blocked.
• Abrasive contains impuri -
ties or is moist.
• Wear protective goggles.
• Unscrew tank lid.
• Remove sand.
• Close the uptake tube (blue tube) in the tank (by bending), so
that no air can escape.
• Hold the sandblasting nozzle on the handpiece closed with
the other hand.
• Using a setting of 4 to 6 bar pressure, activate the foot switch
repeatedly in succession.
• Before re-filling with sand, check the tank and sandblasting
material for contamination or moisture. If necessary replace
with new sand.
• Re-fill with sand and secure the tank lid. (Continue sandblast -
ing in the usual manner).
Install new filter sets:
- Part no. 90002-8889
25-70 µm
- Part no. 90002-8888 70-500 µm
(Refer to the insert for the appropriate filter set):
• Disconnect the compressed air supply to the mixing chamber.
• Unscrew the plug-in connection.
• Remove the old filter sets.
• Run a thin (1 mm) wire through the opening in the mixing
chamber.
• Install new filter sets as follows (number of components ac -
cording to the filter set– smooth (colour marked) side facing
the mixing chamber):
1. Screen
2. Filter, thin
3. Filter, thick
4. Screen
5. Spacer
Reinstall the screw-on connections in the reverse order.
Make certain their is no abrasive residue on the threads.
Attention: Never operate the unit without filters!
Do not reinstall used filter sets!
• Replace the abrasive.
Unit blasts con-
tinuously.
• Foot switch connected
incorrectly.
• Valve in foot switch is
defective.
• Inspect/correct the foot switch connection.
• Replace foot switch.