Renesas M30830T-RPD-E, Руководство пользователя

Страница: 66 / 74

( 66 / 74 )
(2) EMEM Dialog Box is Not Displayed When the Emulator Debugger Starts Up
(When the target system is connected)
Table 6.2 Checkpoints of errors when starting up the emulator debugger (target is connected)
Error
Communication error occurred.
Data was not sent to the target.
Target system cannot be properly built.
PD308 version is not the same version as
the firmware in the target.
Target MCU is in the reset state.
Target MCU cannot be reset.
Target is in "HOLD" state.
Target clock is stopped.
Target MCU is not receiving power.
Checkpoint
Check all emulator debugger settings, interface cable
settings and switches on the rear of the PC4701 match.
See the instruction manuals of the PC4701 and emulator
debugger.
(1) Download the proper firmware.
See "4.2 Downloading Firmware" (page 48).
(2) Recheck the connection between the PC4701 and
this product.
See "3.5 Connecting the PC4701 and Emulation
Pod" (page 34).
Download the proper firmware.
See "4.2 Downloading Firmware" (page 48).
(1) Check if the reset pin of the target system is pulled up.
(2) Check if the reset pin of the target system has
changed from "L" to "H" level.
(1) Check pin NMI* is held high.
(2) If in memory expansion mode or microprocessor
mode, check pins RDY* and HOLD* are "H" level.
(3) If the reset circuit of the target system has a watchdog
timer, disable the timer.
(4) Check power is properly supplied to the target system
and that the target system is properly grounded.
(5) The program may be uncontrollable in areas where
memory is not allocated. Recheck the map setting.
See "4.3 Starting Up the Emulator Debugger (Setting
EMEM Dialog Box)" (page 49).
(1) The MCU is either in the stop mode or wait mode.
Either reset the MCU or cancel the mode with an
interrupt.
See MCU specifications.
(2) The program may be uncontrollable in areas where
memory is not allocated. Recheck the map setting.
See "4.3 Starting Up the Emulator Debugger (Setting
EMEM Dialog Box)" (page 49).
(1) Check the oscillation circuit of the target system is
oscillating properly.
(2) Check the switches in the emulation pod are correctly
set.
See "3.2 Switch Settings" (page 25).
Check power is properly supplied to the target system
and that the target system is properly grounded.