Renesas M30830T-RPD-E, Руководство пользователя

Страница: 49 / 74

( 49 / 74 )
4.3 Starting Up the Emulator Debugger (Setting EMEM Dialog Box)
The EMEM dialog box will appear after setting the Init dialog box by starting up the emulator
debugger or completing downloading the firmware. Here explains how to set processor mode of the
target MCU, allocate the emulation memory and set the emulator work area. Figure 4.3 shows the
EMEM dialog box display.
Figure 4.3 EMEM dialog box
(1) Setting the Debug Monitor Bank Address
With this product, 64 consecutive KB of the emulator's work area are allocated to the debug monitor.
When "F0" is specified, 64 KB starting from address F00000h are allocated for use by the debug
monitor. Specify an unused area.
IMPORTANT
Notes on Setting Debug Monitor Bank Address:
• It is not possible to view or set the content of the specified area. Even on the dump
window or in the reverse assemble area of the program/source windows, the content
of this area is not displayed correctly though it can be displayed.
• The below bank addresses cannot be set for the debug monitor.
(1) MCU internal resources (RAM/SFR area)
(2) DRAM area or multiplex area
(3) Interrupt vector area
1. Debug monitor bank address
2. Processor mode
3. Allocation of the
internal ROM area
4. Display of the level of
each pin
5. Allocations of the expansion
emulation memory