( 27 / 74 )
Table 3.2 Switch settings of the M30830T-RPD-E (2/4)
CNV
SS
SW5
SW6
BYTE
Pulls down pin CNV
SS
with a resistance of 33 k
Ω
(when the target system is unconnected in single-
chip mode or memory expansion mode).
Be sure to set this when using the emulation pod
without the target system.
Connects pin CNV
SS
to the target system.
Pulls up pin CNV
SS
with a resistance of 33 k
Ω
(when the target system is unconnected in
microprocessor mode).
Be sure to set this when using the emulation pod
without the target system.
Connects pin BYTE to the target system.
Pulls up pin BYTE with a resistance of 33 k
Ω
(when the target system is unconnected in 8-bit
bus mode).
Be sure to set this when using the emulation pod
without the target system.
Pulls down pin BYTE with a resistance of 33 k
Ω
(when the target system is unconnected in 16-bit
bus mode).
Be sure to set this when using the emulation pod
without the target system.
RDY*/
HOLD*
SW4
Pulls up pins RDY* and HOLD* of the MCU with a
resistance of 33 k
Ω
. Be sure to set this when using
the emulation pod without the target system.
Connects pins RDY* and HOLD* of the MCU to the
target system.
Signal
Switch
Setting
Description
SW4
RDY/HOLD
OPEN
H
SW4
RDY/HOLD
OPEN
H
SW5
CNVss
H
L
SW5
CNVss
H
L
SW5
CNVss
H
L
SW6
BYTE
H
L
SW6
BYTE
H
L
SW6
BYTE
H
L
Factory-setting
Factory-setting
Factory-setting
Содержание M30830T-RPD-E
