Once all parameters for your WLAN network have
been correctly saved, the heat pump will connect
with your network. You can check this via the "Net-
work USB" parameter. "Connect" must be dis-
played here (if all data is correct). To view the heat
pump data on a smartphone, tablet or laptop,
make a note of the IP address that comes after the
identifier "connected".
Overview (expert)
¯
Information
¯
Basic information
¯
Network (USB)
connected (IP address)
WLAN function
After the parameters described above have been
set, activation is complete. To return to the basic
display, exit the parameter level via the arrow at
the top left or touch the "Overview" symbol.
To connect the REMKO Smart-Control Touch
with your router, the WLAN network must be
received by the controller with sufficient signal
strength!
When you enter the IP address provided in your
web browser, you access the basic display of your
heat pump controller. You now have the option of
controlling the relevant operating parameters for
the user and expert level of your REMKO heat
pump via a PC, laptop or smartphone.
This function is available to you constantly whilst
connected to the WLAN network of your router.
Outside of your network, you have no further
access to the parameters of your controller.
If you require the option of accessing the parame-
ters of your controller outside of the actual WLAN
network, this is only possible with the REMKO
Smart-Web function.
This supplementary software can be additionally
ordered and installed on the Smart-Control Touch
controller.
Please observe the separate operating instructions
for the REMKO Smart-Web function in this regard.
35
