ID
Description
Desig. Details
ID7070 High pressure switch
HP 1
The high pressure switch was triggered
ID7071 Inverter interlocked
HP 1
Inverter interlocked
ID7072 Inverter malfunction
HP 1
Inverter malfunction
ID7073 DLT probe fault
HP 1
Temperature probe DLT was not detected
ID7074 Fan malfunction
HP 2
Fan malfunction
ID7075 Low pressure
HP 2
Pressure transducer P1
ID7076 Overheating point
undershot
HP 2
Temperature below overheating point for too long
ID7077 Overheating point
exceeded
HP 2
Temperature above overheating point for too long
ID7078 High pressure malfunc-
tion
HP 2
Pressure transducer P2
ID7079 Envelope alarm
HP 2
The compressor ran outside its usable limits for too long
ID7080 High heat gas tempera-
ture
HP 2
The maximum hot gas temperature has been exceeded
ID7081 4-way valve fault
HP 2
Pressure difference too low
ID7082 Expansion valve fault
HP 2
The expansion valve was not detected
ID7083 Fault with probe P1
HP 2
Pressure transducer P1 was not detected
ID7084 Fault with probe P2
HP 2
Pressure transducer P2 was not detected
ID7085 Fault with probe T1
HP 2
Temperature probe T1 was not detected
ID7086 Fault with probe T2
HP 2
Temperature probe T2 was not detected
ID7087 Fault with probe T3
HP 2
Temperature probe T3 was not detected
ID7088 Fault with probe T4
HP 2
Temperature probe T4 was not detected
ID7089 Fault with probe T5
HP 2
Temperature probe T5 was not detected
ID7090 Fault with probe T7
HP 2
Temperature probe T7 was not detected.
ID7091 Inverter communication
error
HP 2
Communication with the inverter was interrupted
ID7092 High pressure switch
HP 2
The high pressure switch was triggered
ID7093 Inverter interlocked
HP 2
Inverter interlocked
ID7094 Inverter malfunction
HP 2
Inverter malfunction
ID7095 DLT probe fault
HP 2
Temperature probe DLT was not detected
ID7096 Anti-freeze protection
HP 2
The anti-freeze protection in the heat pump's heat exchanger
was triggered due to a return temperature that is too low. After
rectifying the cause of the error, reset the error in (Expert/
Settings/Heat pump/Basic settings) and, if necessary, de-ener-
gise the outdoor unit
ID7097 Flow switch (contact
open)
Open contact of the flow switch (jumper plug) during defrost /
cooling mode
ID7098 Logic error source cir-
cuit
Logic error source circuit - medium flow rate in the source cir-
cuit with closed valve
REMKO Smart-Control Touch
96
