Source buffer tank
Optionally, the "Source buffer tank" function can be activated. Activation must take place when the heat
pump is used as a heat source of the buffer tank for supplying the REMKO MWL heat pumps. If the heat
pump is not required as a heat source for the MWL heat pumps, activation of this function is not necessary
and remains deactivated!
Menu item
Parameter
Factory setting
Source buffer tank
Activated
Deactivated
Deactivated
Domestic hot-water heating
Optionally, you can activate or deactivate the "Domestic hot-water heating" function. Activate domestic hot-
water heating if domestic water has to be heated for washing or showering. When this function is activated,
the associated parameters are then queried. Pay attention to information on the display.
Menu item
Parameter
Factory setting
Domestic hot-water heating
Activated
Deactivated
Deactivated
Storage tank set temperature
Desired temperature for the domestic hot water.
If there is a solar yield, the storage tank can become substantially warmer. The maximum temperature for
solar charging can be modified under Settings/Solar/Storage tank.
For efficiency reasons, the lowest possible set temperature should be selected. If the available quantity of
hot water is insufficient, the value should be increased. Pay attention to the maximum temperature of the
heat pump.
Menu item
Parameter
Factory setting
Storage tank set temp.
40 °C - 65 °C
Factory recommendation 45°C
Hot water circulation
If there is a hot water circulation pump in the building, which you are intending to operate in an energy-
saving manner using the controller, this function must be activated.
Menu item
Parameter
Factory setting
Hot water circulation
Deactivated
As required
Activated
REMKO Smart-Control Touch
78
