4
Assembly
4.1
System layout
3
1
2
B
A
D
C
a
b
Fig. 3: System layout
1:
Cold water inlet
2:
Ambient air
3:
Hot water
A:
Compressor
B:
Condenser
C:
Thermal expansion valve
D:
Evaporator
a:
Low water temperature
b:
High water temperature
4.2
General installation notes
DANGER!
Danger of death!
Only authorised specialist personnel are per-
mitted to remove the front panel and the upper
cover plate once the power plug has been
unplugged, because contact with live parts
poses a danger of death!
NOTICE!
Never tilt the unit more than 15 degrees for an
extended period of time. The unit can be tipped
by a max. 60° for short-term transport only.
Proceed with caution when lifting and lowering
the unit. Horizontal storage or transportation is
not permissible!
n
These instructions are to be observed when
installing the heat pump.
n
The unit should be delivered as near as pos-
sible to the site of installation in its original
packaging in order to avoid transport damage.
n
The unit is to be checked for visible signs of
transport damage. Possible faults are to be
reported immediately to the contractual partner
and the haulage company.
n
Suitable sites for installation are to be selected
with regard to machinery noise and the set-up
process.
n
Establish all electrical wiring in accordance
with the relevant DIN and VDE standards.
n
The electrical power cables must always be
fastened to the electrical terminals in the
proper manner. Otherwise there is a risk of fire.
n
Make sure that pipes carrying water do not
pass through living or sleeping areas.
11
Содержание RBW 300 PV
Страница 9: ...Lid dimensions 620 mm 460 mm 300 mm 150 mm 150 mm 160 mm 400 mm Fig 2 Lid dimensions 9...
Страница 45: ...45...
Страница 46: ...REMKO RBW 46...
Страница 47: ......
